features reliable low cost construction utilizing molded kbu plastic technique ideal for printed circuit board low forward voltage drop low reverse leakage current high surge current capability mechanical data case: molded plastic, kbu epoxy: ul 94v-o rate flame retardant terminals: leads solderable per mil-std-202, method 208 guaranteed mounting position: any weight: 0.3ounce, 8.0gram maximum ratings and electrical characteristics ratings at 25 ?? ambient temperature unless otherwise specified. single phase, half wave, 60h z , resistive or inductive load. for capacitive load, derate current by 20%. symbols KBU8005 kbu801 kbu802 kbu804 kbu806 kbu808 kbu810 units maximum recurrent peak reverse voltage v rrm 50 100 200 400 600 800 1000 volts maximum rms voltage v rms 35 70 140 280 420 560 700 volts maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 volts maximum average forward rectified current .375"(9.5mm) lead length at t a =55 ?? peak forward surge current, 8.3ms single half-sine-wave superimposed on rated load (jedec method) maximum forward voltage at 8.0a dc and 25 ?? maximum reverse current at t a =25 ?? at rated dc blocking voltage t a =100 ?? typical thermal resistance (note 2) r ja ?? /w typical thermal resistance (note 3) r jc ?? /w operating and storage temperature range t j ? tstg ?? notes: 1- units mounted in free air, no heatsink, p.c.b. at 0.375" (9.5mm) lead length with 0.5 x 0.5? (12 x 12mm) copper pads 2- units mounted on a 3.0 x 3.0? x 0.11" thick (7.5 x 7.5 x 0.3cm) al. plate heatsink i r amp amp volts uamp 1.1 8.0 dimensions in inches and (millimeters) i (av) i fsm v f 125 -55 to +125 10.0 500 18 3 KBU8005 thru kbu810 silicon bridge rectifier http://www.trr-jx.com
KBU8005 thru kbu810 silicon bridge rectifier charact eristic curves (t a =25 unl ess otherwise noted) http://www.trr-jx.com 25 50 75 100 125 150 0
|